[OpenSIPS-Users] Dispatcher module disable gateway after X failures, auto re-enable after some time

[Bogdan-Andrei Iancu]

Hi Adam,

Maybe such a custom logic is outside OpenSIPS scope - still have you 
considered using the ds_set_state MI function to control from outside 
the status of the destinations ? Of course you will have to use the 
Event Interface too, to receive the notifications on the destination 
status (when OpenSIPS is doing the state transition) - see the 
E_DISPATCHER_STATUS event 
(http://www.opensips.org/html/docs/modules/2.3.x/dispatcher.html#idp5746368)

So, when OpenSIPS switches a destination into probing (based on a 
failure detection), you can get the event and force the destination into 
Inactive ; after some custom amount of time, you can put it back into 
Probing mode, to allow OpenSIPS to re-enable it.

Regards,

Bogdan-Andrei Iancu
   OpenSIPS Founder and Developer
   http://www.opensips-solutions.com

On 10/28/2017 04:13 PM, Adam Raszynski wrote:
> Hi
>
> Could you suggest some working configuration of the dispatcher module 
> for the following setup:
>
> - Flag gateway as failed (even if it's still responding to OPTIONS) 
> after some number of consecutive call failures. That's the easy part
>
> - Automatically un-flag gateway after some time, to allow re-checking 
> (reset failure counter?)
>
> - Ideal solution would also include increasing re-check interval, ie 
> first re-check after 1 minute, if next failure detected next re-check 
> after 2 minutes, next after 4 and so on
>
>
> Best Regards
>
>
>
> _______________________________________________
> Users mailing list
> Users at lists.opensips.org
> http://lists.opensips.org/cgi-bin/mailman/listinfo/users

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opensips.org/pipermail/users/attachments/20171031/81bbc702/attachment.html>