[OpenSIPS-Users] dispatcher not doing fail over itself

[Bogdan-Andrei Iancu]

Hi,

As mentioned, place the avp_print() just after you did the 
ds_select_dst(), before relaying to the first destination.

Regards,

Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
http://www.opensips-solutions.com

On 17.09.2014 14:09, Satish Patel wrote:
> Confirmed  probing/inactive thing is working,
>
> Now problem is failover not working, ds_next_dst() not able to find next gateway and it says no more gateway available. If you check my script, i am calling failure route and inside it calling ds_next_dst() but you are saying do avp_print() on ds_select_dst() it won't print anything because after failure you are in failure route block.
>
> Please advice if my script has any issue.
>
> Sent from my iPhone
>
> On Sep 17, 2014, at 3:30 AM, Bogdan-Andrei Iancu <bogdan at opensips.org> wrote:
>
>> Hi Satish,
>>
>> Use the "opensipsctl fifo ds_list" to see the status of the gws in realtime . Be sure that once a gw is in non-active state (probing or inactive), it will not be used again for routing. Just take care of doing the ds_next_dst() in order to jump to the next available gw.
>>
>> If you do the avp_print() after ds_select_dst(), you can see how many other gw are prepared to used in case of failover.
>>
>> Regards,
>>
>> Bogdan-Andrei Iancu
>> OpenSIPS Founder and Developer
>> http://www.opensips-solutions.com
>>
>> On 16.09.2014 21:02, Satish Patel wrote:
>>> After doing couple of TEST look like its marking "Probing" for failed gateway but not auto failover to next gateway, i meant call get disconnect and i need to re-initiate call then all call goes to second active gateway..
>>>
>>> I believe it should first mark gateway "Probing" and then fall-back to second gateway automatically instead of call disconnect and i am getting 503 error code on my SIP Phone.