[OpenSIPS-Users] sst module killing calls

Bogdan-Andrei Iancu bogdan at opensips.org
Wed Feb 2 23:17:02 CET 2011


Hi Jeff,

If you set the sst flag for an Invite, the sst module will force the SST 
support, even if not present in the received INVITE  - could you check 
if the outbound INVITE has the SE and MIN-SE headers added ?

Regards,
Bogdan

Jeff Pyle wrote:
> Hello,
>
> I'm experimenting with the sst module once again.  It's configured as 
> follows:
>
>   modparam("dialog|sst", "timeout_avp", "$avp(s:dialog_timeout)")
>   modparam("sst", "sst_flag", 6)
>   modparam("sst", "min_se", 30)
>
> Dialogs are set for all calls.
>
> Calls I sent contain the following header:
>   Session-Expires: 30
>
> So far, so good.  When I get a 200 OK from a carrier that supports 
> sst, I see the following headers:
>   Supported: timer
>   Session-Expires: 30;refresher=uas
>
> (The 30 second expiration is an experimentally low value.)  When I get 
> a 200 OK from a carrier that doesn't support sst, I don't see those 
> two headers.  In this case it seems the sst module still sets the 
> dialog expiration to 30 seconds, after which the call goes poof.
>
> Is that correct behavior?  If neither end advertise support for sst, 
> and neither side is going to refresh it, it seems a bit strange the 
> sst module would still cause the dialog to expire at the expiration time.
>
>
> - Jeff
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Users mailing list
> Users at lists.opensips.org
> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>   


-- 
Bogdan-Andrei Iancu
OpenSIPS Event - expo, conf, social, bootcamp
2 - 4 February 2011, ITExpo, Miami,  USA
OpenSIPS solutions and "know-how"





More information about the Users mailing list