[Users] Out of Memory
Bogdan-Andrei Iancu
bogdan at voice-system.ro
Thu Jun 22 20:10:03 CEST 2006
Hi Douglas,
I when over the dumps you get, but there is no increasing memory
consumption in time (some number of used mem chunks). Also the first
line shows:
Memory status (pkg):
qm_status (0x8121ba0):
heap size= 1048576
used= 21908, used+overhead=248632, free=799944
so only 25% is used from the 1M available.
Please check that you are actually sending the SIGUSR1 signal to the
process that generated the memory error (it's about the per-process
memory and not the shared one). So, wait for the error to occur, send
the signal to the reporting process and please send me the log (no need
to post again on web).
regards,
bogdan
Douglas Garstang wrote:
>Bogdan,
>
>I finally managed to upload the memory dumps to pastebin. Links are:
>Hopefully you can access them.
>
>Memory dump right after OpenSER was started: http://pastebin.com/723872
>Memory dump after OpenSER running for 20min: http://pastebin.com/723890
>Memory dump after OpenSER running for 50min: http://pastebin.com/723902
>
>The problem started to occur between the 20 and 50 minute samples. About 20 calls had been processed in that time.
>
>Douglas.
>
>
>
>>-----Original Message-----
>>From: Bogdan-Andrei Iancu [mailto:bogdan at voice-system.ro]
>>Sent: Wednesday, June 21, 2006 10:14 AM
>>To: Douglas Garstang
>>Cc: Users at openser.org
>>Subject: Re: [Users] Out of Memory
>>
>>
>>As written in the wiki, if you do not know how to interpret
>>the result,
>>you should post them on a ftp or http server and send the link to the
>>list - also, important is to mention in which context did you get the
>>mem dump - is the shutdown dump, a run time dump...
>>
>>regards,
>>bogdan
>>
>>
>>Douglas Garstang wrote:
>>
>>
>>
>>>Once I get the memory status, how do I interpret the results?
>>>
>>>
>>>
>>>
>>>
>>>>-----Original Message-----
>>>>From: Bogdan-Andrei Iancu [mailto:bogdan at voice-system.ro]
>>>>Sent: Wednesday, June 21, 2006 9:43 AM
>>>>To: Douglas Garstang
>>>>Cc: Users at openser.org
>>>>Subject: Re: [Users] Out of Memory
>>>>
>>>>
>>>>Hi Douglas,
>>>>
>>>>it was signal SIGUSR1 and not SIGHUP - I strongly advice you
>>>>to go through
>>>> http://openser.org/dokuwiki/doku.php?id=memory
>>>>note you have to recompile and reinstall in order to be able to do
>>>>memory debug.
>>>>
>>>>also does not matter how much mem. your system has - openser
>>>>will use by
>>>>default only 1M per process. Refer to the wiki for how to
>>>>
>>>>
>>increase it.
>>
>>
>>>>Regards,
>>>>Bogdan
>>>>
>>>>
>>>>
>>>>
>>>>
>
>
>
More information about the Users
mailing list