[Users] more on accounting

[tele]

Hi,

Can you point me to some documentation about the ftag parameter in the
RR/Route header?
I've search in the RFCs but not found any informations about.

thank you

On Mon, 2006-07-10 at 14:44 +0300, Bogdan-Andrei Iancu wrote:
> Hi,
> 
> in this case it means that the UA you were using was not correctly using 
> via the RR/Route headers and the RR header inserted by OpenSER was not 
> correctly mirrored into a Route hdr - this header is used to determine 
> the direction of the sequential requests.
> 
> regards,
> bogdan
> 
> tele wrote:
> 
> >Hi bogdan,
> >
> >now it works i can see the debug messages and OpenSER correctly swap
> >From/To for the accounting.
> >
> >But i didn't change the config, the only thing is that now signalling
> >message come from another proxy and not directly from UA.
> >
> >thank you for the support.
> >
> >On Mon, 2006-07-03 at 09:44 +0200, tele wrote:
> >  
> >
> >>Hi Bogdan,
> >>
> >>I've updated to last CVS-head version. but in the log i can't see debug 
> >>messages.
> >>maybe there is an error in my accounting configuration. pls have a look:
> >>
> >>modparam("acc", "log_level", 2)
> >>modparam("acc", "log_fmt", "cdfimorstup")
> >>modparam("acc", "report_ack", 0)
> >>modparam("acc", "detect_direction", 1)
> >>modparam("acc", "radius_flag", 3)
> >>modparam("acc", "radius_missed_flag", 5)
> >>modparam("acc", "radius_config", 
> >>"/usr/local/etc/radiusclient-ng/radiusclient_auth.conf")
> >>modparam("acc", "radius_extra", "h323-setup-time=$avp(setup_time); 
> >>h323-connect-time=$avp(connect_time); 
> >>h323-disconnect-time=$avp(disconnect_time); 
> >>h323-remote-address=$avp(remote_address)")
> >>
> >>and before loose_route() i have:
> >>
> >>if (is_method("BYE"))
> >>{
> >>        setflag(3);
> >>        setflag(5);
> >>};
> >>
> >>is it correct?
> >>
> >>Bogdan-Andrei Iancu wrote:
> >>
> >>    
> >>
> >>>Hi,
> >>>
> >>>as I saw in the log, the FROM restoring in BYE works properly, so 
> >>>RR/Route processing is fine. Are you sure you enabled the accounting 
> >>>for BYE?
> >>>
> >>>just in case, I added some more debug messages about this on cvs - 
> >>>please update and see the output. You should get:
> >>>   DBUG:acc:acc_onreq: UPSTREAM req detected -> flaging it
> >>>and
> >>>   DBUG:acc:fmt2strar: UPSTREAM flag set -> swap F/T
> >>>      
> >>>
> >>
> >>_______________________________________________
> >>Users mailing list
> >>Users at openser.org
> >>http://openser.org/cgi-bin/mailman/listinfo/users
> >>    
> >>
> >
> >
> >_______________________________________________
> >Users mailing list
> >Users at openser.org
> >http://openser.org/cgi-bin/mailman/listinfo/users
> >
> >  
> >
>